Z-Silver Elastomeric Connectors provide low resistance connections in many component-to-board and board-to-board applications.
Z-Silver Elastomeric Connectors are typically used to mate Flex Circuits or PC Boards to LCD Modules, EL Displays, LED Backlights and other PC Boards.
Due to the silicone construction of Z-Silver Elastomeric Connectors, they conform to the contact surfaces of the mating substrates to create a gasket-like seal that withstands environmental conditions.
In addition, the elasticity of Z-Silver Elastomeric
Connectors provides superior performance in applications that require resilience to shock and vibration.
These low-cost connectors are available in custom sizes to accommodate the specific needs of your application.
|
Z-Silver Connector
without insulation |
Z-Silver Connector
with foam padding
or solid silicone |
Z-Silver Connector
with insulation |
 |
| Foam, solid silicone, and insulation are all available in any combination and on one or both sides of a Z-Silver Elastomeric Connector. |
|
| DIMENSIONS |
| |
inches |
mm |
| Height(H) |
.040 +/- .003
to .500 +/-
.010 |
1.0 +/- 0.08
to 12.7 +/-
0.25 |
| Width(W) |
.020 +/- .002
to .100 +/-
.006 |
0.51 +/- 0.05
to 2.54 +/-
0.15 |
| Length(l) |
.035 +/- .005
to 2 +/- .010
to 8
+/- .020 |
0.89 +/- 0.125
to 50 +/- 0.25
to 203 +/- 0.5 |
| Recommended Height/Width ratio is 1.5:1 to
5:1 |
|
| NOMINAL
SPECIFICATIONS |
|
Conductive Layers: |
100 per inch
39.37 per cm |
200 per inch
98.43 per cm |
|
Layer Thickness: |
.005"
0.127mm |
.0025
0.064mm |
Deflection: 5 - 20%
Clamping Force Per Linear Inch: 8DW (lbs.)
|
|
|
TYPICAL PROPERTIES |
| Contact Resistance: |
0.1
Ohms |
| Current Carrying Capacity: |
1A
|
Resistance Between
Conductor Layers: |
10*E12
Ohm - min. |
| Dielectric Constant: |
2.8 |
Temperature
Range:
|
Standard:
-40 to 125 degrees C
Low Temp:
-65 to 125 degrees C |
| Humidity Range: |
0 to 100% non-condensing
|
Layer
Durometer:
|
Conductive: 60 Shore A
Non Conductive: 50 Shore A |
|
|
